SPEED DENSITY CONVERSION KIT 2009-2018 R35 GTR
DescriptionSpeed Density Conversion Kit for the R35 GTR. 100% Plug-N-Play. For those seeking to make more than 700whp (Dynojet) running... read more
Speed Density Conversion Kit for the R35 GTR. 100% Plug-N-Play.
For those seeking to make more than 700whp (Dynojet) running upgraded turbochargers this is your answer. (Or for those wanting to convert to Vent-to-Atmosphere Blow-Off Valves.)
The factory 5.0 Volt MAF sensors in 3″ aftermarket intake tubing will support roughly 700whp, as which point they are no longer able to meter the increased air volume. Converting to Speed Density Tuning is your answer for higher HP levels than the MAF sensor can support.
This OEM Nissan (Hitachi) Tmap sensor measures Intake Air Temperature and Boost Pressure, all-in-one…relocating your Intake Temperature reading post Intercooler from the factory MAF sensors. This sensor uses factory scaling for a direct PNP install with no tuning changes required.
We offer two version: MAF Delete & MAF is retained.
If you have emissions testing where you live, you’ll need to retain your Mass Air Flow Sensors.
Conversion Plug-N-Play wiring harness makes installation a breeze. This install takes roughly 5 minutes with a single 10mm Metric Socket needed to swap out sensors.
- 2 lbs
- 11 × 7 × 4 in
- Retain MAF Sensor
Yes, No Thanks
|Nissan||R35 GTR||2009 - 2018|
SCT X4 Performance Programmer
ECUTEK PROECU Licenses ONLY TCM + ECM GT-R
Burger Motorsports JB4 Mobile Connect Kit